添加量
释义
- additive amount
实用场景例句
- 全部
The inhibition ratio, could be achieved more than 93 % by the 0.01 % pigment addition.
天然萝卜红色素的抗氧化能力与同浓度的BHT相近, 0.01%的添加量即可达到93%以上的抑制率.
互联网
The perfect dosage of each aid is: CS 1 %, CPAM 0.02 % , silica - aluminum microparticle 0.1 % ~0.3 %.
硅铝微粒助留体系的助留助滤性能明显好于阳离子淀粉/CPAM双 组分体系,各助剂的最佳添加量为阳离子淀粉1% 、 CPAM0.02% 、 硅铝微粒0.1%~0.3%.
互联网
Comprehensively , magnesium hydroxide filling amount of 100 was the best recommended value.
所以综合各因素考虑,氢氧化镁添加量为100份时最适宜.
互联网
The tear strength and elongation of PTFE reduce when filler content increases.
随着填料添加量的增加,抗拉强度和伸长率降低.
互联网
In this test, the best addition of wheat gluten is 4 %.
在该试验条件下, 谷朊粉最佳添加量为4%.
互联网
Recommended dosage: modifier 0.2 % ( dry powder dollars ), by 0.1 % emulsified oil.
建议添加量: 改良剂0.2% ( 干粉计 ), 乳化油0.
互联网
Linear effect level of lecithin ( P 0.01 ).
1卵磷脂添加量呈直线效应 ( P<0.01 ).
互联网
When additionvolume of starch was 0.5~1.0 % , cross - linked and GCWS acetylation of starch showed very goodeffects.
实验得出其适宜添加量为0.5~1.0%,应用效果较好.
互联网
The optimum additive amount of fluidity improver H 89 2 have also been sutied.
确定了流动性改进剂H89-2的最佳添加量.
互联网
Thermal conductivity and specific heat decrease while thermal diffusivity increases with the increase of space - holder addition.
随着造孔剂添加量的增大,毛细芯的导热系数和单位体积热容显著减小,热扩散系数明显增大.
互联网
The effects of starch content in adhesive on bonding strength and water resistance were examined.
考察了小麦淀粉添加量对脲醛树脂胶应用于松木胶接时的胶合强度和耐水性能的影响.
互联网
Wear rate will be the lowest when the addition content of graphite term of mass.
其中添加石墨后的复合材料硬度明显高于不添加石墨的基体合金硬度,石墨添加量(质量分数)为1%时复合材料的磨损率最低.
互联网
The crystal nucleus formation and growth and then slow with the increasing addition of starch.
随着淀粉添加量的增加,钙沉淀过程晶核生成和生长速率先减小后增大.
互联网
The relationships between thermo physical properties and porosity, forming pressure and space - holder addition were investigated.
总结得到了热物性参数与孔隙率以及制备这些毛细芯所使用的成型压力和造孔剂添加量之间的关系.
互联网
Changing type and content thein films can control the photodegradation rate of films.
的类型和添加量可以调节薄膜的光降解速度.
互联网
收起实用场景例句
- 释义
- 实用场景例句